Need help?Do you have a question about the Wet Sounds HTX-5 and is the answer not in the manual?
General| Channels | 5 |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | >90 dB |
| THD at Rated Power | < 1% |
| Input Sensitivity | 200mV - 4V |
| Crossover Frequency | Variable |
Warns about potential hearing damage from high volume listening and local laws.
Advises checking installation location for hidden wires or devices before cutting.
Details how to prepare and connect power wires (+12V and Ground) to the terminal block.
Explains connecting the remote turn-on wire to activate/deactivate the amplifier with the source unit.
Explains connecting RCA outputs and selecting input modes for channel output configuration.
Details connecting speaker wires to removable terminal blocks for secure power connections.
Explains the input sensitivity gain controls for different channel pairs.
Covers variable crossovers and crossover switches for high-pass (HPF) and low-pass (LPF) filtering.
Details connecting the positive 12V power and ground terminals to the battery.
Provides a 3-step process for setting the amplifier's gain without distortion.
Lists initial checks for fuses, wiring, voltage, and LED status for troubleshooting.
Details amplifier fault codes indicated by LED flashing sequences for diagnostics.
To Next Page
