Wetelecom WM-D200 - Program Installation and Setup; System Requirements

7
ENG
2. PROGRAM INSTALLATION
2.1. INTRODUCTION
This section describes step-by-step method to install
WM-D200 USB MODEM and MTS Connect Software.
2.2. MINIMUM SYSTEM REQUIREMENT
2.2.1. PC Hardware
• Recommend to use PC/Notebook at speed of 300 MHz
or higher. Minimum 233 MHz speed required, Intel
Pentium/Celeron products, AMD K6/Athlon/Duron
products or compatible processors
• Recommend to use 128MB RAM or higher
• Minimum of 64MB memory is required, however, the
performance will be degraded and certain features will
be limited.
• At least 100 MB of free hard disk space is required.
• Motherboard or PCI card that supports USB.
• Video adaptor with Super VGA (800 × 600) or higher
resolution and Monitor
• CD-ROM or DVD Optical Drive
• Keyboard and Mouse