Need help?Do you have a question about the Wetrok Duomatic Intense and is the answer not in the manual?
General| Brand | Wetrok |
|---|---|
| Model | Duomatic Intense |
| Category | Floor Machine |
| Language | English |
Read operating instructions carefully and keep them handy before commissioning.
Explanation of warning symbols and operating instructions, not for dangerous situations.
Part number 52084, rear working lip for 79 PUR 45.
Part number 52085, front sealing lip for 79 PUR 45.
Key safety measures to follow during setup and operation, including protective gear.
Important notes regarding machine operation and electrical connections.
Guidelines for safe operation, cleaning chemical use, and machine handling.
Important information about the emergency stop button and machine stopping procedures.
Details the emergency stop button, stopping procedures, and cleaning agent usage.
Step-by-step guide for filling water and chemicals into the dosing system.
Step-by-step guide for filling water without the dosing system.
Adjusting the handle height based on operator's height for proper positioning.
Procedure for turning on the machine using the power button.
Pressing the brush button activates all cleaning functions.
Instructions on how to adjust the water flow rate.
Procedure for lifting brushes and adjusting their pressure for optimal cleaning.
Procedure for lowering the suction nozzle before starting operation.
Activating the drive lever starts all selected functions.
General information about performing cleaning tasks.
Instructions for emptying the clean and dirty water tanks.
Procedure for cleaning the machine's brushes and suction nozzle.
Instructions for releasing the brushes using the designated button.
Procedure for rinsing the scrubbing brushes after use.
Instructions for cleaning the brush housing.
Steps to remove the suction nozzle, including loosening star knobs.
Procedure for detaching the dirty water hose from its support.
Instructions for rotating or replacing the suction lips.
Procedure for cleaning the suction nozzle.
Steps for replacing the suction lips.
Steps for cleaning the fresh water filter, including unscrewing the viewing pane.
Instructions for cleaning the filter screen.
Warning about potential overheating of the drive and limiting fast run button use.
Hoses must be replaced annually by Wetrok or authorized personnel.
General safety guidelines for cleaning, maintenance, and repair, including electrical safety.
Daily inspection of the mains connection cable for damage or aging.
Annual or 500-hour service recommended, performed by Wetrok or authorized specialists.
Table listing faults, their causes, and recommended solutions for machine operation issues.
Troubleshooting steps for short battery life, including charging and surface application.
Troubleshooting steps if the brush housing fails to lower, related to brush button setting or overload protection.
Troubleshooting steps if brush motors are not rotating, related to brush button setting or overload protection.
Troubleshooting for suction motor issues, checking button settings, overload protection, or panel messages.
Troubleshooting steps if the machine or battery cannot be charged, checking power cord and outlet.
Troubleshooting for brake issues, checking holding brake status and contacting Wetrok service.
Troubleshooting for low or no chemical solution, checking dosing system and canister.
Troubleshooting for water supply issues, checking water settings, tank level, and filter.
Instructions for cleaning or replacing the fresh water filter.
Troubleshooting steps for poor cleaning results due to dirty/worn brushes/pads, incorrect chemical dosage, or wrong method.
Troubleshooting for streaks on the floor, related to suction lips.
Troubleshooting for lack of suction, checking hose connection, blockages, lid closure, and suction lips.
Technical specifications for Endurer 60/75 Dosing models, covering performance, dimensions, and batteries.
To Next Page
