Whale SDS236T - Page 3

Important Information
Please read the following information before setting up a Bluetooth
®
wireless technology connection
between the Whale Instant Match
®
transformer and Mira
®
Advance Flex Extra (J09Nn or J09N) shower:
• The electrical wiring must conform to EU wiring regulations BS7671: 2018 (18th Edition).
• The Bluetooth
®
function of the Whale Instant Match
®
transformer will only work with the Mira
®
Advance Flex Extra (J09Nn or J09N) shower.
• For optimum signal strength, mount the transformer within 5 metres of the shower within the same room.
• Locating the transformer outside of a 5 meter radius or in a different room can cause a communication
breakdown between the transformer and shower, resulting in intermittent or complete failure to operate.
• The Bluetooth connection is only to be used where the transformer is installed in the bathroom with
the shower. Where the transformer is installed in a boxing only plastic access panels are to be used.
• A hardwired connection must be established if a Bluetooth
®
wireless technology connection cannot be
made between the shower and transformer.
• If any component or cord is damaged, it must be replaced by a qualified person to avoid a hazard.
WARNING
Plumbing of the Waste Pipe
Bluetooth
®
wireless technology
A wireless Bluetooth connection may be used to allow the
SDS236T (755.699 / 755.678) Whale Instant Match
®
transformer
to communicate with the Mira Advance Flex Extra (J09Nn or
J09N) shower without the use of a physical hardwired connection
or external flow sensor to activate the pump. To set up
the wireless connection, please follow the process below.
For Mira Flex Extra Advance (J09N) showers manufactured after
Week 2 2019 and those manufacturer prior to this date.
The production date label is located on the base of the shower.
2