Set Up
1. Shower and Transformer settings
• Before starting the Bluetooth
®
pairing process, please ensure that the "BLE Pump Enable"
switch inside the front cover of the Mira
®
Advance Flex Extra has been set to the "ON"
position, and that the “Wired Pump Mode” and "Reserved 2" switches remain in the "OFF"
position as per the diagram shown.
• At this stage, please ensure that your transformer is set to position 7 for “Bluetooth”
and the pipe inlet diameter must be set to 1 for 15mm.
Whale
Transformer
Settings
Blue Jumper - Sensor Position 7
Grey Jumper - Over run 10 Seconds
Red Jumper - Pipe inlet 15mm
43 DEG C
45 DEG C
RESERVED 1
ECO
RESERVED 2
BLE PUMP ENABLE
WIRED PUMP MODE
3
Mira Advance
Flex Extra - J09Nn or J09N
To Next Page
Loading...
