Plumbing of the Waste Pipe
4
• Turn on power to the shower using the pull cord.
• This will automatically pair the shower and pump.
2. Configuring the shower
1. Transformer set up
• Switch the mains electric supply to the transformer
ON and wait to hear the audible beep from the transformer.
The light on the transformer will now flash red to indicate
that a Bluetooth
®
connection has not yet been established.
• Press and HOLD the blue test button on the transformer
until the light flashes red and green to indicate that the
transformer is now in pairing mode.
NOTE: You now have 120 seconds to pair the transformer
to the shower.
Pairing Process
To Next Page
