Fig. 27 Installed control panel
Fig. 28 Connect 12V connector
Fig. 29 Connect 12V to interface plate
Fig. 30 Completed installation
Fig. 31 Completed installation under vehicle
Fig. 32 Control panel
Fig. 33 Flue Type - for vehicle in motion
Fig. 34 Flue Type - for standard installation
This Whale® Space Heater Mk II is a gas only blown air space heater. Nominal heat output is 2kW on gas. The
compact design provides versatility in installation locations and needs minimal maintenance. The vehicle internal
temperature is set by a room controller which can be manually adjusted to a wide range of temperature settings or to
warm weather ventilation. Key enhancements to the Mk II design are improved insulation, improved service access
and a lighter more compact design.
Read the following carefully before installation
Model: SH2201 (inside vehicle) Maximum dimensions: Height: 230mm, Width: 157mm, Length: 634mm
SH2211 (under-floor) Maximum dimensions: Height: 121mm, Width: 290mm, Length: 714mm
Countries of Destination: AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, HR, IE, IS, IT, LT, LU, LV,
MT, NL, NO, PT, SE, SI, SK, TR
Weight: Inside Vehicle Installation 7.7kg
Under-floor Installation 7.7kg
Gas: Butane 28-30mbar - CAT I
3+
(28-30/37), Butane/Propane 30mbar - CAT I
3B/P
(30)
Propane 37mbar - CAT I
3p
(37)
Gas Consumption (M) 150g/h
Classification of Heater: Type: C
53
(Fanned) Normal Installation
C
13
Vehicle In Motion Installation
Nominal Heat Input: Gas 2.0kW
Battery Supply
Nominal voltage: 12V d.c.
Operating range: 10.0V d.c. min. to 15V d.c. max.
Maximum current d.c. gas operation: 1.7 Amps (0.01Amps on standby)
Maximum current d.c. electric operation: 2.2 Amps (0.01Amps on standby)
Dry Storage Temperature: -20°C to 70°C
Hot Air Duct Diameter: 60mm ID
Flue Diameter: 22mm ID
Maximum Exhaust Flue Length: 2m
Minimum Exhaust Flue Length: 0.75m
Maximum Combustion Air Flue Length: 2m
Minimum Combustion Air Flue Length: 0.75m
2. SPECIFICATION
1. PRINCIPLES OF OPERATION
2
To Next Page
Loading...
