Need help?Do you have a question about the Wharfedale Pro MP 1200 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Power Output | 1200W |
| Channels | 2 |
| Frequency Response | 20Hz - 20kHz |
| Input Sensitivity | 0.775V |
| Input Impedance | 20kΩ balanced, 10kΩ unbalanced |
| Cooling | Variable speed fan |
| Connectors Input | XLR, 1/4" TRS |
| Connectors Output | Speakon, Binding Post |
| Power Supply | AC 220-240V, 50/60Hz |
| Amplifier Class | Class AB |
| Damping Factor | >200 |
| Protection | Short circuit, overload, thermal |
Instructions for checking the product after delivery for any physical damage.
Details the warranty terms for MP Series Power Amplifiers.
Crucial safety guidelines to reduce the risk of electric shock and ensure proper use.
Details voltage and frequency considerations for safe operation.
Describes the intended use and target audience for the MP range amplifiers.
Provides details on the MP series models and their design for professional use.
Pre-operation checks and procedures before switching on the amplifier.
Information regarding Class 2 wiring standards for audio output terminals.
Indicates when overheating or DC voltage is present at the outputs.
Signals distortion reaching approximately 0.1% on each channel.
Separate level controls for each input channel to adjust gain.
The switch used to turn the AC power to the amplifier on and off.
Light that illuminates when the amplifier is powered on.
Describes the XLR and 1/4" TRS input connectors for signal reception.
Selector for Stereo or Bridged mono operation.
Specifies the output power ratings for different impedance loads.
Warning to not obstruct the cooling vents for proper heat dissipation.
Connection for AC power cord and location of the fuse.
Ensuring proper airflow for the cooling fans in a dust-free environment.
Guidance on connecting loudspeakers using binding posts or Speakon connectors.
Details wiring for electronically balanced XLR and 1/4" Jack inputs.
Instruction to plug the AC input cord into the AC outlet.
How to bridge two stereo channels for higher mono output power.
Power output ratings for MP 1200 and MP 1800 in stereo and bridged modes.
Specifies input sensitivity and impedance for balanced and unbalanced connections.
Details voltage gain and slew rate for stereo and bridged modes.
Information on channel separation and signal-to-noise ratio.
Specifications for distortion levels and frequency response range.
Details damping factor and amplifier topology (Class AB).
Lists input and output connector types.
Overview of front and rear panel controls.
Lists the various indicators on the amplifier.
Information on the cooling system.
Provides gross weight, net weight, and physical dimensions.
Diagrams for balanced input connections using XLR and 1/4" Jack.
Diagrams for unbalanced input/output connections using mono 1/4" Jack.
Explanation of balanced vs. unbalanced systems and ground loop prevention.
How the amplifier protects itself from high temperatures by shutting down.
How the amplifier detects and responds to accidental output short circuits.
To Next Page
