5
Adjustable wrench that opens
to 25mm (1") or hex-head
socket wrench (for adjusting
dryer feet)
6,2 mm (1/4") nut driver
Utility knife
Level
Tape measure
Pliers
Vent clamps
Flat-blade screwdriver Wire stripper
(direct wire installations)
Tin snips
(new vent installations)
INSTALLATION REQUIREMENTS
Tools and Parts:
Gather required tools and parts before starting installation.
DRYER DISPOSAL
#2 Phillips screwdriver
Putty knife
Tools needed for Gas installations:
204 mm (8") or 254 mm (10")
pipe wrench
Pipe joint compound
resistant to LP gas
Caulking gun and
compound (for installing
new exhaust vent)
To Next Page
Loading...
