Whirlpool ADG 130 - User Manual

GB
-1-
Chart
PROGRAMS
SELECTION
BUTTON
Push “Programs”
button (repeatedly)
until the indicator of
the required
program lights up
(see “Table of
programs” - next
page).
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
HALF LOAD
BUTTON
Half load cycle can be
used for the upper or
lower rack. Select the
required program
then press the “Half
Load” button - the
light comes on. Turns
off at the end of the
program. The “Half
Load” option can be
used with the
programs indicated in
the table of
programs.
DELAYED
START BUTTON
The wash cycle
can be
programmed to
start after 2, 4 or 8
hours. Then press
the Start button.
The wash
program will start
after the set time.
START/RESUME
BUTTON
Push this button to
start the selected
program: the indicator
lights up and goes off at
the end of the
program. When the
door is opened during
a washing cycle, the
cycle is temporarily
paused: the Start
indicator blinks.
To resume the cycle
push Start button and
close the door within 3
seconds.
SALT
INDICATOR
When lit (at the
end of the
cycle), the salt
reservoir needs
to be refilled.
RINSE AID
INDICATOR
When lit (at the
end of the
cycle), the rinse
aid dispenser
needs to be
refilled.
5019 396 01914ADG 130
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds
(until the indicator lights
up) if you are using the
combined detergents in
tablet (rinse aid, salt and
deteregent in 1 dose). If
you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
CANCEL/OFF
BUTTON
Push this button to switch
off the control panel.
If pressed when a
program is running it
cancels the program
ongoing draining water
for 1 minute.
If pressed when the
dishwasher is switched
off it drains any possible
liquids from dishwasher
(1 minute process).
If the indicator flashes
repeatedly, see page 9 -
chapter ”What to do if ...”.
Quick reference guide

Summary

Control Panel Overview

Control Panel Operation

Details how the control panel activates and deactivates automatically.

Water Hardness and Salt Management

Setting Water Hardness for First Use

Setting water hardness for optimal cleaning results before first wash.

Filling the Salt Reservoir

Instructions for filling the salt reservoir, especially before the first wash.

Starting and Operating the Dishwasher

Program Selection and Cycle Control

Managing Wash Cycle Options

Instructions for pausing, cancelling, or changing a program.

Maintenance and Care Procedures

Cleaning the Dishwasher Filters

How to check and clean filters.

Troubleshooting Common Dishwasher Faults

Appliance Not Starting or Responding

Troubleshooting steps for appliance not starting.

CANCEL;Off Lamp Blinking 6 Times

Troubleshooting for CANCEL/Off lamp blinking 6 times.

CANCEL;Off Lamp Blinking 8 Times

Troubleshooting for CANCEL/Off lamp blinking 8 times.

Troubleshooting Dish Cleaning and Drying Issues

Resolving Food Residues on Dishes

Solutions for dishes with food residues after washing.

Improving Dish Drying Performance

Troubleshooting steps for dishes not drying properly.

General Safety, Precautions, and Disposal

Comprehensive Safety Warnings

General safety precautions for operating the appliance.

Whirlpool ADG 130 Specifications

General

Type	Freestanding
Energy efficiency class	A
Delay Start	Yes
Half Load Option	Yes
Dimensions (H x W x D)	85 x 60 x 60 cm