EasyManua.ls Logo

Whirlpool ADG 7470/1 - User Manual

Whirlpool ADG 7470/1
8 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GB
-1-
Chart
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if ...”.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused: the
Start indicator blinks.
To resume the cycle push the Start button and
close the door within 3 seconds.
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Table of programs
Deter-
gent
Consumption
P
Programs Loading instructions
Litres kWh
Minutes
1)
1 Pre-Wash cold
Crockery to be washed later. — 5.0 0.02 10
2 Quickwash 40°C
Lightly soiled crockery, with no
dried-on food.
X 13.0 0.70 30
3
Eco
2)
50°C
Normally soiled crockery.
Energy-saving program.
X 15.0 1.05 165
4 Intensive 70°C
Recommended program for
heavily soiled crockery, especially
suitable for pans and saucepans.
X 15.0 1.50 140
5019 396 01961ADG 7470
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Quick reference guide

Table of Contents

Other manuals for Whirlpool ADG 7470/1

Preview: Assembling Instructions
Assembling Instructions40 pages

Questions and Answers

  • R
    Richard GarciaAug 20, 2025
    Why is my Whirlpool Dishwasher not working?
    • G
      Gerald GoodAug 20, 2025
      Your Whirlpool Dishwasher might not be working because it is not switched on, the door isn't closed properly, or the delayed start option is activated. Ensure the dishwasher is powered on and the door is securely closed. If the 'Delayed start' option is on, the appliance will start when the set time elapses; reset it to '0' to start immediately. Also, check the household circuit fuse if there is no power supply.
  • B
    Bernard ArmstrongAug 22, 2025
    What to do if my Whirlpool Dishwasher leaves crockery and cutlery with food residues?
    • G
      gdayAug 22, 2025
      If your Whirlpool Dishwasher leaves food residues on dishes, make sure that items don't touch each other, arranging concave items facing downwards. Use enough detergent, that is not too old and stored correctly. Select a wash program with a higher temperature for heavily soiled crockery. If you're using the Half load/Multizone option, load only the upper or lower rack. If you often use the Eco 50°C program, occasionally select the Intensive 70°C program. Ensure the spray arms aren't clogged, filters are clean and correctly fitted, and spray arms can turn freely.
  • A
    Austin ClarkAug 25, 2025
    How to fix a Whirlpool ADG 7470/1 when the CANCEL/Off indicator lamp blinks 6 times and the wash program ended too early?
    • W
      William JacksonAug 25, 2025
      If the CANCEL/Off indicator lamp blinks 6 times and the wash program ended too early on your Whirlpool Dishwasher, the filters might be dirty or clogged. Also, there might be too little water in the dishwasher’s water system, or the drain hose might be incorrectly fitted. High level of foam inside might be the reason. Ensure the filters are clean, arrange concave items facing downwards, and fit the drain hose correctly, leaving min. 200-400 mm from the lower edge of the appliance. Repeat without detergent or wait until foam disappears.
  • D
    David MillerAug 26, 2025
    Why are my Crockery and cutlery not dry after using Whirlpool Dishwasher?
    • K
      Kimberly WrightAug 26, 2025
      If crockery and cutlery are not dry after using your Whirlpool Dishwasher, it could be because plastic containers don't dry well, clean dishes are left in the dishwasher too long, concave items are arranged incorrectly, the rinse aid dosage is incorrect, or a rapid program was selected. Wipe synthetic materials dry. Try releasing the door 5 minutes before removing the dishes. Arrange crockery so that water does not collect in cavities. Increase the rinse aid dosage. Select a standard-length program instead of the Rapid program.
  • J
    Joseph PopeAug 28, 2025
    Why does my Whirlpool Dishwasher have deposits: regeneration salt residue on crockery and cutlery?
    • H
      Heather HeathAug 28, 2025
      If your Whirlpool Dishwasher leaves regeneration salt residue on crockery and cutlery, it could be due to hard water, an open salt reservoir cap, or not enough rinse aid. Add more regeneration salt in areas with very hard water. Close the salt reservoir cap properly. If you use a combined action detergent, try adding more rinse aid.
  • J
    Jason WalshAug 30, 2025
    What does it mean when the CANCEL/Off indicator lamp blinks 6 times on my Whirlpool ADG 7470/1 Dishwasher?
    • S
      Sharon SchmidtAug 30, 2025
      If the CANCEL/Off indicator lamp blinks 6 times on your Whirlpool Dishwasher, it could be due to a closed water tap, a kinked water inlet hose, clogged inlet filters, or low water pressure. Ensure the water tap is open, the inlet hose isn't kinked, and the inlet filter in the water tap connector is clean. Also, make sure the water tap is fully open during water inlet, providing a minimum capacity of 0.5 liters per minute.
  • W
    Whitney JohnsonSep 1, 2025
    What to do if the CANCEL/Off indicator lamp blinks 8 times on my Whirlpool ADG 7470/1?
    • M
      Martin PetersonSep 1, 2025
      If the CANCEL/Off indicator lamp blinks 8 times on your Whirlpool Dishwasher, it could be due to dirty filters, a kinked drain hose or a closed syphon hose connection. Clean the filters, ensure the drain hose isn't kinked, and remove the closure disk from the syphon hose connection.
  • M
    Michael WilkinsSep 3, 2025
    Why does my Whirlpool ADG 7470/1 Dishwasher leave discoloured plastic parts on crockery and cutlery?
    • M
      Mrs. Tanya MannSep 3, 2025
      If your Whirlpool Dishwasher leaves discoloured plastic parts on crockery and cutlery, it may be due to tomato or carrot juice. Use powder detergent and programs with higher wash temperatures.
  • C
    Cynthia BarnesSep 5, 2025
    Why does my Whirlpool ADG 7470/1 leave removable deposits on glasses?
    • D
      David KellySep 5, 2025
      If your Whirlpool Dishwasher leaves removable deposits on glasses, it may be due to usage of incorrect programs for glasses. Dishes should be put together, to avoid touching each other. Do not put glassware together in baskets. Use suitable program for glass.
  • D
    David GriffinSep 7, 2025
    Why does my Whirlpool ADG 7470/1 leave other marks?
    • J
      Joseph PriceSep 7, 2025
      If your Whirlpool Dishwasher leaves other marks, it could be due to rinse aid dosage being too low. Increase the rinse aid dosage. If you use a combined action detergent, possibly add more rinse aid.

Summary

Quick Reference Guide Overview

Program Selection Button

Instructions for selecting a wash program using the button and indicator.

Start;Resume Button

Details how to start, pause, and resume a wash program.

Cancel;Off Button

Describes how to cancel a program or switch off the appliance.

Table of Programs

Lists wash programs, loading instructions, and consumption data.

Setting Water Hardness

Water Hardness Levels

Table detailing water hardness in different units and corresponding levels.

Setting the Water Hardness

Step-by-step guide to set the appliance's water hardness level.

Salt Reservoir Management

Filling the Salt Reservoir

Instructions for filling the salt reservoir before the first wash.

Salt Indicator Status

Explains the salt indicator lights on the control panel and reservoir cap.

Rinse Aid Management

Adding Rinse Aid

How to fill the rinse aid dispenser and adjust dosage.

Rinse Aid Indicators

Explains the control panel and dispenser rinse aid indicators.

Detergent Usage

Adding Detergent

Instructions on how to add detergent to the dispenser.

Loading the Dishwasher Racks

Loading the Upper Rack

Guidance on arranging items in the upper rack.

Adjusting Upper Rack Height

Instructions on how to adjust the upper rack for optimal loading.

Loading the Lower Rack

Guidance on arranging items in the lower rack.

Removing the Upper Rack

Instructions on how to remove the upper rack for bulky items.

Loading Precautions

General advice on crockery arrangement and item suitability.

Program Operation

Selecting a Program

How to choose the appropriate wash program.

Wash Cycle Management

How to pause, resume, cancel, or change a running program.

Switching Off the Appliance

How the appliance switches to standby and how to turn it on.

Maintenance and Care

Cleaning the Filters

Steps for checking and cleaning the appliance filters.

Cleaning Spray Arms

Instructions for removing and cleaning spray arms.

Troubleshooting Common Issues

Appliance Not Starting

Checks for when the appliance does not turn on or start.

Error Indicator Lights

Explains what blinking CANCEL/Off indicator lights signify.

Crockery Not Clean

Addresses issues with food residues or poorly cleaned items.

Troubleshooting Crockery Issues

Salt Indicator and Deposits

Explains salt indicator, deposits, and regeneration salt issues.

Drying and Spotting Problems

Addresses items not drying, glasses not sparkling, or streaks.

Discoloration and Marks

Explains causes for discolored plastic, tea cup stains, and rust marks.

Suds and Streaks

Troubleshoots excessive suds and streaks on dishes.

Safety and General Precautions

Disconnecting Power and Water

Instructions on how to disconnect the appliance before service.

Contacting After-Sales Service

Information needed when contacting service for faults.

General Recommendations

Covers packing, energy saving, child safety, and operating limits.

Resistance to Frost

Measures to protect the appliance from freezing temperatures.

Disposal Guidelines

Information on how to safely and environmentally dispose of the appliance.

Whirlpool ADG 7470/1 Specifications

General IconGeneral
BrandWhirlpool
ModelADG 7470/1
CategoryDishwasher
LanguageEnglish

Related product manuals