Why my Whirlpool ADG 221 does not start?
If your Whirlpool dishwasher doesn't start or cannot be controlled, here are a few things to check: * Ensure the water supply tap is turned on. * Try switching the appliance off and on again using the ON/OFF button, waiting about a minute before restarting. * Verify the dishwasher is properly plugged into a working electricity socket. * Make sure the dishwasher door is fully closed.
What to do if my Whirlpool Dishwasher won't drain water?
If no water drains out of your Whirlpool dishwasher, consider the following: * Ensure the wash cycle has fully finished. * Check the water drain hose for any bends. * Inspect the drain duct for clogs. * Examine the filter for food residues and clogs. * Verify the height of the drain hose.
How to fix Whirlpool Dishwasher that is not cleaning dishes properly?
If your dishes aren't clean after a wash cycle in your Whirlpool dishwasher, consider these potential causes and solutions: * Ensure dishes are arranged properly so they are not blocking the spray arms. * Make sure the spray arms can rotate freely. * Select a more intensive wash cycle. * Use the correct amount of suitable detergent. * Ensure the rinse aid compartment lid is correctly closed. * Clean a dirty or clogged filter. * Check the refined salt level. * Ensure the height of the dishes is compatible with the rack adjustment. * Check the holes in the spray arms and clean them if they are clogged.
Why my Whirlpool Dishwasher is not drying dishes?
If your crockery isn't drying properly in your Whirlpool dishwasher: * Ensure that you have selected a wash cycle that includes a drying programme. * Check if the rinse aid has been used up. * Verify that the rinse aid dispenser setting is correct. Note that water drops are normal on crockery made from non-stick material or plastic.
How to remove white film from dishes in Whirlpool ADG 221?
If your dishes and glasses are covered in a white film or limescale deposits after washing in your Whirlpool dishwasher: * Ensure the dishwasher has refined salt. * Adjust the water hardness setting to a suitable level. * Make sure the salt and rinse-aid dispenser caps are closed properly. * Check that the rinse aid hasn't been used up and the dosage is adequate.
Why does my Whirlpool Dishwasher leave streaks on glasses?
If dishes and glasses from your Whirlpool dishwasher are streaked or have a bluish tinge, the rinse aid dosage may be too high.
Why Whirlpool ADG 221 Dishwasher won't load water and has flashing lights?
If your Whirlpool dishwasher won’t load water and shows flashing lights, check these items: * Confirm that there is water in the mains supply and the tap is open. * Inspect the water inlet hose for bends. * Clean any clogged filters. * Clean the clogged drain duct. After checking and cleaning, switch the dishwasher on and off and start a new wash cycle. If the problem continues, turn off the water tap, remove the plug.
How to reduce noise from my Whirlpool Dishwasher?
If your Whirlpool dishwasher is making excessive noise, consider the following: * Ensure that dishes are not rattling against each other or the spray arms, and that the spray arms can rotate freely. Place the dishes properly. * Make sure you are using the correct amount of suitable detergent and that you are not pre-washing dishes by hand, as too much foam can cause noise.
What to do if Whirlpool Dishwasher door won't close?
If the door of your Whirlpool dishwasher won’t close: * Ensure that the racks are fully inserted. * Make sure that the lock was released and strongly push the door until a 'clacking' noise is heard.
General| Brand | Whirlpool |
|---|---|
| Model | ADG 221 |
| Category | Dishwasher |
| Language | English |
To Next Page