Whirlpool ADG 758 - Technical Data; Dimension; Wooden Door Specifications; Electronic Boards

SERVICE
16.11.2005 / Page 2 ADG 758 Whirlpool Europe
Doc. No: 4812 728 11715 8511 155 10811 Customer Service
Technical data
Dimension
Height 82.0 - 87.0cm
Width 44.8 cm
Depth 57.0 cm
Weight 36 kg
Wooden door for Full Door appliances
Thickness min. 16 mm
Thickness max. 20 mm
Width min. 442 mm
Width max. 448 mm
Height min. 650 mm
Height max. 720 mm
Weight min. 2.5 kg
Weight max. 6.2 kg
Max. stick out over lower
edge of appliance door 90 mm
Height of plinth min. 93 mm
Electronic boards
Service boards see spare part list
Succession of programs
Programs see program diagram
Succession Prewash, cold
Delicate 45˚
Bio/ Eco 55˚
Normal 65˚
Intensive 70˚
Datas Energy Label
Reference program Bio/ Eco 55˚
Energy Performance B
Cleaning Performance A
Drying Performance B
Alarms
Refill rinse aid
Refill salt
Option
Delay function
Program information
End - Acoustic signal
All programs will be locked after start. Changing
the program or finishing the program will be
possible only after pressing the start button for
longer then 1.5 sec. (Break by customer)
A switching off the appliance or unplug the
appliance for a while, this will frozen the program
step and later on, the program continuos on the
same position.
If the tank temperature is over 50 ˚C the program
will restart 15 seconds after the door is closed to
avoid overpressure inside the tank.
Exception: Switching off the appliance or unplug
the appliance during the drying phase, this will lead
directly to the end of the program.
Volume
Detergent 48 ccm
Clear rinse containing 140 ccm
Adjustable 1 - 6
Rinse aid dosage 1 - 4 ccm
Capacity 10 stand. place settings
Water connection up to 60 ˚C
Electrical base data
Voltage 220-230 V
Frequency 50 Hz
Total power 2.2 kW
Fuse 10 A
Spray pump motor
Voltage 220-240 V ± 10%
Frequency 50 Hz
Power consumption 150 W
Rotation 2950 RPM
Capacitor 6 µ F
Resistance (20˚C)
primary winding ~ 44 Ω± 7%
start winding ~ 50.5 Ω± 7%
Drain pump motor
Voltage 220-240 V ± 10%
Frequency 50 Hz
Power consumption 34/ 30 W
Resistance winding 155/ 170 Ω± 10%
Maximal head 1 m
Maximal flow rate 20 l/min
Heating - 1 Element flow through system
Voltage 230 V
Power consumption 2.04 kW
Resistance 25 Ω± 10%
Thermal protection 98 ˚C ± 5˚C
Thermal Fuse 206 ˚C ± 10˚C