GB
-1-
Chart
PROGRAMME
SELECTION BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required programme
lights up (see “Table of
programmes” below).
START/RESUME BUTTON
Push this button to start the selected programme:
the indicator lights up and goes off at the end of the
programme. When the door is opened during a
washing cycle, the cycle is temporarely paused: the
Start indicator blinking. To restart the cycle close
the door and push Start button again.
BUTTON
Push this button to switch on or switch off the control panel.
If pressed when a programme is running it cancels
the programme ongoing.
If the indicator flashes repeatedly, see page 5 -
chapter ”What to do if ...”.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Table of programmes
Deter-
gent
Consumption
P
Programmes Loading instructions
Litres kWh
Minutes
1)
1
Pre-Wash cold
Crockery to be washed later. — 5.0 0.02 10
2
Quickwash 40°C
Lightly soiled crockery, with no dried-
on food.
X 13.0 0.70 30
3
Eco
2)
50°C
Normally soiled crockery. X 15.0 1.05 150
4
Intensive 70°C
Recommended programme for heavily
soiled crockery, especially suitable for
pans and saucepans.
X 17.0 1.65 145
5
Half Load 50°C
Ideal for washing a half load of lightly or
normally soiled crockery.
X 13.0 1.00 130
5019 396 01824ADP 2315
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
Quick reference guide
To Next Page
Need help?
General
