To Next PageTo Next Page
Need help?Do you have a question about the Whirlpool ADP 941/1 WH and is the answer not in the manual?
General| Type | Freestanding |
|---|---|
| Color | White |
| Wash Programs | 6 |
| Height | 85 cm |
| Width | 60 cm |
| Depth | 60 cm |
| Washing Class | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Annual Water Consumption | 3920 L |
Physical dimensions and decor plate specifications for the dishwasher.
Capacity, water consumption, program time, alarms, and water volumes.
Detergent usage, water softener details, and water pressure specifications.
Rotational speeds of motors, spray arms, and water flow rates.
Voltage, frequency, power consumption, fuse ratings, and base electrical data.
Details on motors, heating element, thermostat, and heating relay.
Electrical resistance and voltage data for valves, potentiometers, and NTC sensors.
Salt consumption for regeneration based on water hardness levels.
Explanation of symbols and abbreviations used in the circuit diagram.
Explanation of the program sequence indicator lights (LEDs) during operation.
Step-by-step instructions for performing the service test program.
How failures are indicated via LED flashes and alarms for Whirlpool/Ignis.
Procedure and sequence for the passive test program.
Failure indications with digits and passive test program for Bauknecht appliances.
Steps, indications, and important remarks for the active test program.
Analysis and possible causes for NTC break failure.
Identification and causes of water leakage in the dishwasher.
Troubleshooting heating system defects and relay issues.
Diagnosing draining failures related to pump, siphon, or water indicator.
Causes and implications of spray arm blockage or sensor issues.
Troubleshooting water tap closed issues and flow meter faults.
Diagnosing flow meter failures and related water inlet problems.
Identifying water level failures due to indicator, sieve, or foam.
Causes of continuous water inlet, including valve and triac faults.
Table detailing available wash programs for different appliance types.
Explanations of prewash, glass, rapid, bio/eco, normal, and intensive programs.
Testing control board functions via test points T0, T1, T2, T3 on WP/IG.
Testing Bauknecht control board functions via test points T0, T2, T3.
