What to do if my Whirlpool AWM 5500 Washer won't start?
If your Whirlpool Washer isn't starting and no lights are on, try these steps: First, ensure the appliance is properly plugged into a functioning wall socket by testing with a table lamp. Then, make sure the ON/OFF button is pressed, the water tap is open, the door is completely closed (child safety), and a program has been correctly selected and started.
What to do if my Whirlpool AWM 5500 won't drain?
If your Whirlpool Washer isn't draining, consider these potential solutions: * Check the drain hose installation. * Inspect the filter for blockages. * See if the drain hose is frozen. * Ensure the 'Rinse hold' button isn't activated.
How to stop my Whirlpool AWM 5500 Washer from vibrating?
To reduce vibration in your Whirlpool Washer during the spin cycle: * Ensure the appliance is level and firmly installed on all four feet. * Verify that the transit bolts have been removed before using the appliance.
Why are the spin results poor on my Whirlpool AWM 5500?
Poor final spin results on your Whirlpool Washer can occur due to several reasons. If laundry is too wet, try adding smaller items to balance the load and repeat the spin cycle. Also, excessive foam can prevent spinning, so ensure you're using the correct amount of detergent. The program might be interrupted due to no water supply or a blocked pump. If the pump is blocked, switch off the appliance and clean the pump, then restart the appliance.
Why is there no water coming into my Whirlpool Washer?
If your Whirlpool Washer isn't getting enough water, check the following: * Make sure the tap is fully turned on. * Inspect the water hose for any kinks. * Check if the water hose filter is blocked. * Ensure the water hose isn't frozen. If it was frozen, switch the appliance off and then on again.
What does Water Stop fault mean on my Whirlpool AWM 5500?
A Water Stop fault on your Whirlpool Washer could be due to too much foam or a leakage in the inlet hose or appliance. If there's too much foam, switch off the appliance, unplug it, and close the water tap. If there's a leakage, carefully tilt the appliance forward to drain the water, then reconnect it, open the tap, reselect the program, and press 'On/Off'.
Why is there detergent left in my Whirlpool AWM 5500 Washer dispenser?
Residue in the dispenser of your Whirlpool Washer after a wash can be due to the siphon not being correctly installed or needing cleaning. Also, insufficient water supply could be the cause. Check if the mesh filters between the inlet hose and the tap are clogged and clean the filter two or three times a year.
Important warnings to prevent children from playing with the washing machine.
Checks for when the washing machine fails to power on or start.
Troubleshooting steps for when the cycle is interrupted unexpectedly.
Diagnosing issues related to water intake problems.
Solutions for when the machine fails to drain water.
Explains why residues appear and how to prevent them.
Checks for excessive vibration during the spin cycle.
Addresses issues related to the water leakage detection system.
Reasons for damp laundry after the spin cycle and how to improve results.
Instructions for removing securing bolts before first use.
How to level the appliance using adjustable feet for stability.
To Next Page
General