EasyManuals Logo

Whirlpool COOK20 MWP 201 User Manual

Whirlpool COOK20 MWP 201
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
GB
PAUSE OR STOP COOKING
ADD / STIR / TURN FOOD
STANDBY MODE
To pause cooking:
The cooking can be paused to check, add or turn or stir the food by opening the door.
The function will be stopped if to press STOP button during cooking.
The setting will be maintained for 5 minutes.
To continue cooking:
Close the door and press the Jet Start button. The cooking is resumed from where it was
paused.
If you don’t want to continue cooking you can:
Remove the food, close the door and press the Stop button.
When the cooking is finished:
The display will show the text “End”. An acoustic beep will signal once a minute for 2 minutes.
Please note that reducing or stopping this programmed cooling cycle will not have a ne-
gative impact on the function of the product.
Depending on the selected function, it could be needed to add / stir / turn food during
cooking. In these cases the oven will pause cooking and it will ask you to perform the nee-
ded action.
When required, you should:
* Open the door.
* Add or Stir or Turn the food (depending on the required action).
* Close the door and restart by pressing Jet Start button.
Notes: if the door is not opened within 2 minutes from the request to Add or Stir or Turn
the food, the microwave oven will continue the cooking process (in this case the final re-
sult may not be the optimal one).
i
START PROTECTION / CHILD LOCK
This automatic safety function is activated one minute after the oven has returned to
“Stand-by mode.
When the safety function is active the door must be opened and closed in order to start
the cooking, otherwise the display will show door.
DOOR
The oven is in Stand-by mode when the clock is displayed (or, if the clock has not been set,
when the display will show “:”).
ECO STANDYBY: The function is set in order to have power saving. During Standby mode,
you can press “+“ and “-“ buttons simulaneously to enter ECO STANDBY mode. After cook-
ing end, the display will show time or “:“ for 10 seconds then go to ECO STANDBY mode.
Press the two buttons again to quit the mode.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Whirlpool COOK20 MWP 201 and is the answer not in the manual?

Whirlpool COOK20 MWP 201 Specifications

General IconGeneral
BrandWhirlpool
ModelCOOK20 MWP 201
CategoryMicrowave Oven
LanguageEnglish

Related product manuals