Whirlpool DWF 405 S - Technical Data; Appliance Dimensions and Doors; Program and Energy Data; Water and Detergent System

SERVICE
23.05.2002 / Page 2 DWF 405 S Whirlpool Europe
Doc. No: 4812 718 18048 8545 405 01770 Customer Service
Technical data
Dimension of Built In appliances Full Door and
Integretable types
Height 82.0-87.0 cm
Width 59.7 cm
Depth 55.5 cm
Weight 53 kg
Wooden door for Integrable types
Thickness min. 16 mm
Thickness max. 20 mm
Width min. 592 mm
Width max. 595 mm
Height min. 515 mm
Height max. 600 mm
Weight max. 5.5 kg
Max. stick out over lower
edge of appliance door 92 mm
Height of plinth min. 93 mm
Electronic boards
Service boards see spare part list
Serial boards see on the boards itself
UB 4619 724 21071
Programing of version and programmed control
board, see „Service“ and „Data set“ on rating
plate of inner door:
CB programmed 468591
Data set 468581
Basic control board, not programmed see on the
board itself 4619 724 17401
Succession of programs
Programs see program diagram
Succession P1a - P3a - P5b - P7a
Datas Energy Label
Reference program P5b
Energy Performance C
Cleaning Performance B
Drying Performance D
Program information
Start indicator
All programs will be locked after start. Changing
the program or finishing the program will be
possible only after pressing the start button for
longer then 1.5 sec. (Break by customer)
A switching off the appliance or unplug the
appliance for a while, this will frozen the program
step and later on, the program continuos on the
same position.
Exception: Switching off the appliance or unplug
the appliance during the drying phase, this will lead
directly to the end of the program.
Water Volume at permanent spray system
Water Volume Level
Regeneration 0.3 l 15 mm
Back rinse 3x 1.0 l 60 mm
Prewash 4.8 l 120 mm
Main wash 4.2 l 118 mm
Intermediate rinse 1 4.2 l 118 mm
Intermediate rinse 2 4.2 l 118 mm
Clear rinse 4.2 l 118 mm
Safety/ overflow 8.5 l 141 mm
Measuring the level
Remove the coarse sieve, put in a measuring
meter into the sump, measure the hight of the
water level.
Detergent max.
Pre-wash 10 cm
3
Main-wash 40 cm
3
Rinse aid 135 cm
3
6 Dosage steps 1 - 6 ml
Water softener
Saltcontainer 2 kg
Resin container 900 cm
3
Regeneration dosage 300 cm
3
Water pressure
Inlet pressure 0.3 - 10 bar
Spray pump pressure 0.3 bar