What to do if my Whirlpool Washer stops during the programme and 'Start/Pause' blinks?
- JJessica CarrollAug 2, 2025
If your Whirlpool Washer stops mid-cycle and the 'Start/Pause' button is blinking, here's what might be happening: * **Rinse hold is activated:** You can stop Rinse hold by either draining the water or spinning the laundry. * **Programme was interrupted:** Ensure the door is fully closed and then press 'Start/Pause' to continue the programme. * **Safety system activated:** Check the 'Failure indicators' section. Also, make sure your water tap is open and the inlet hose isn't kinked.