Whirlpool HB10813 - General Failure Treatment

- 16 -
If it is difficult to pull out the filter, please open the front cover to take out the filter:
1.
Open the front cover by
holding the two
sides of front
cover.
2.
Pull out the Pre-filter.

3. Close the front cover and also
press the upper left & right
corners to close it completely.
 Safety Items:
z Do not put your hands into the machine when running, to avoid from injury or
burn by
the heater.
z Do not spray water into the main body, which may damage the motor, or ca
use
electric shock by the electricity leak
age.
z In order to avoid from any accident or injury, if any of the following symptoms
and
abnormal situation occur, please switch off the electricity and ask qualified
electrical engineering contractor for repair or check. (Self repair by user is strictly
prohibited to avoid danger).
ӑ Turn on the power, the fan does not start.
ӑ The po
wer on and off.
ӑ Abnormal sound and vibration during operation.
ӑ Plas
tic smell or other abnormal smell occurs
.
 General Failure Treatment:
Phenomenon
Check
Solution
No operate when the power
turning on
No power supply
Switch
on the power
The
light of the Power
does not light on
Ask the qualified engineer
for repair
The display light does not display
conforming to the function
The machine does not
receive remote control
signal
Align the remote to the
machine or control the
remote in the
receiving
range
Abnormal
noise
Filter blocking
Clean the filter or replace
with a new filter
The remote control does not
work
Low battery
Change the battery