2-7
Clear the water lines
1. Run water through both faucets and in-
let hoses, into a laundry tub, drainpipe or
bucket, to get rid of particles in the wa
-
ter lines that might clog the inlet valve
screens.
2. Check the temperature of the water to
make sure that the hot water hose is con
-
nected to the hot water faucet and that
the cold water hose is connected to the
cold water faucet.
Connect the inlet hoses to the washer
NOTE: Replace inlet hoses after 5 years of
use to reduce the risk of hose failure. Record
hose installation or replacement dates on the
hoses for future reference.
Periodically inspect and replace hoses if bulg-
es, kinks, cuts, wear, or leaks are found.
ROUTE THE DRAIN HOSE
Proper routing of the drain hose protects your
floors from damage due to water leakage.
Read and follow these instructions.
Remove drain hose from the washer
Gently pull the corrugated drain hose from the
shipping clips.
1. Attach the hot water hose to the wash
-
er’s hot (H) water inlet valve. Screw on
coupling by hand until it is seated on the
washer.
2. Attach the cold water hose to the washer’s
cold (C) water faucet. Screw on coupling
by hand until it is seated on the washer.
3. Using pliers, tighten the couplings with
an additional two-thirds turn.
NOTE: Do not overtighten. Damage to
the coupling can result.
4. Turn on the water faucets completely and
check for leaks.
H. Hot water inlet
C. Cold water inle
t
H
C
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated
drain hose.
A
. Snap either end of the drain hose form to the drain hose at
the point where the corrugation begins.
B. Bend drain hose over drain hose form an
d snap into place.
A B
To Next Page
Loading...
Need help?
General
