Until you get used to the settings, use the
following as a guide.
For best results, start
cooking at the high setting; then turn the
control knob down to continue cooking.
SElTING
HI
MED-HI
MED
MED-LO
LO
RECOMMENDED USE
.To start foods cooking.
@To bring liquids to a boil.
.To hold a rapid boil.
@To frv chicken or Dancakes
l For gravy, pudding and
icing.
l To cook large amounts of
vegetables.
l To keep food cooking after
starting it on
a
higher
setting.
l To keep food
warm
until
ready to serve. Set the
heat higher or lower within
the LO band to keep food
at the temperature you
want.
Using the dual-size surface uni
(Model RC864OXB)
You can use the left front and right rear
surface units as either small diameter, lower
wattage elements (center area marked
“DUAL ELEMENT’) or large diameter, full
wattage elements (entire element to outer
ring edge).
To use only the inner area of the element
(for smaller pans):
l
Push in and turn
the
control
knob to the
left (counterclockwise) to the desired
setting in the area marked “SINGLE.”
its
To use the entire element (for larger pans):
l
Push in and turn
the control knob to the
right (clockwise) to the desired setting in the
area marked “DUAL.”
NOTE:
You can turn the control knob in either
direction to reach “OFF.”
To Next Page