Whirlpool RF360BXE - Setting the Self-Cleaning Controls

26
1. Press the auto clean pad.
The clean indicator light will light up.
This will automatically set a 4
1
⁄2-hour
Self-Cleaning cycle.
NOTE: There will be a 30-minute cool-down
1
⁄2 hour before the cycle is over.
2. Start the oven.
NOTE: The on indicator light will light up and the
close door indicator light will flash if the door is
not closed.
3. After Self-Cleaning cycle starts:
The door locked indicator light will light up when
the oven door locks. The door cannot be opened
when the door locked indicator light is on.
4. After Self-Cleaning cycle ends and the oven
reaches normal baking/roasting temperatures:
The clean, door locked, and on indicator lights
will go out.
Press the off/cancel pad to clear the display.
5. After the oven cools to room temperature, wipe
off any residue or ash with a damp cloth or sponge.
If needed, touch up spots with a mild abrasive
cleanser or cleaning sponge.
SETTING THE CONTROLS
AUTO
CLEAN
PRESS YOU SEE
PRESS YOU SEE
START
5 SEC
ENTER
ON
ON
YOU SEE
ON
YOU SEE
ON
PRESS
OFF
CANCEL
USING THE SELF-CLEANING CYCLE