Surface Units and Reflector Bowls
Removing
Burn and Electrical Shock Hazard
Make sure all surface units are OFF before
removlng surface units and reflector bowls.
Failure to do so can result in burns or elec-
trical shock.
1. Turn off all surface units.
3. Pull the surface unit straight away
from the receptacle.
2. Lift the edge of the unit, opposite
the receptacle, just enough to
clear the element hold down clip,
reflector bowl and trim ring.
4. Lift out the reflector bowl and trim
ring. See “Cleaning Chart” on
page 22 for cleaning instructions.
16
To Next Page
Loading...
