Installing it properly
1.
Allow 3 inches (7.5 cm) between overhead
cabinets and refrigerator top.
2. Allow at least 1 inch (2.5 cm) between the
refrigerator condenser on the back and the
wall.
3. Allow ‘/2 inch (1.25 cm) on each side of the
refrigerator for ease of installation.
4. If the hinge side of the refrigerator is to be
against a wall, you might want to leave extra
space so the door can be opened wider.
5. Level your refrigerator.
Leveling it
Your-refrigerator has 2 front, adjustable
rollers to prevent rocking on uneven floors.
To adjust rollers:
1.
Roll refrigerator into position.
2. Adjust rollers by turning the leveling
screws, located at the front of the base.
l Turn clockwise to raise.
l Turn counterclockwise to lower.
NOTE:
Rollers are adjusted correctly
when the refrigerator no longer rocks
when the doors are opened or closed.
3. Repeat this procedure whenever the
refrigerator is moved.
NOTE: If you want the doors to close easier,
use the rollers to raise the front of the
refrigerator slightly.
I I-
Use a screw-
driver to adjust
View of roller
with hinge
in place
Leveling
screw
6
To Next Page
Loading...
