Whirlpool WDF550SAAW - DISHWASHER SAFETY; INSTALLATION REQUIREMENTS; Tools and Parts

DISHWASHER SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER?” or “WARNING.”
These words mean:
You can be killed or seriously injured if you don't immediately
A DANG ER follow instructions.
You can be killed or seriously injured if you don't follow
AWARNING instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
AWARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
You need to: m Install this dishwasher as specified in these instructions.
m Slowly open dishwasher door while someone grasps the rear m Have everything you need to properly install dishwasher.
of the dishwasher. Remove shipping materials. Close a ; ;
dishwasher door. Latch the dishwasher door shut. m Contact a qualified installer to ensure that dishwasher is
; ; installed to meet all electrical and plumbing national and local
m Observe all governing codes and ordinances. codes and ordinances.
INSTALLATION REQUIREMENTS
fools and Paris
Gather the required tools and parts before starting installation. Parts Needed
Read and follow the instructions provided with any tools listed = 90° elbow with 34" N.PT. = 1'" to2" 3.8m to
Tools Needed external threads on one 5.1 cm) screw-type clamp
a: . 5 . end m Clamp connector (strain relief}
m Phillips screwdriver m 6" (15.2 cm) adjustable NOTE: The other end to fit %" (22.2 cm) diameter
m Flat-blade screwdriver wrench must fit the water supply hole
m Measuring tape or ruler Small tubing cutter line. mw 114" to 2” (3.8m to
a Yo" 34" and 1%" (1 3 mm, Level mg Thread seal tape a cm) serew type camp
1.9mm and 3.8 cm) hole Cordless drill m 3 UL listed wire nuts Connecting To Waste-!ee
bit
i
saw
bits
ve"
drill
bit
m
Copper
tubing
m= Shallow pan (@" recommended)
Flashlight