Electric Dryer
PRODUCT MODEL NUMBERS
Dryer with Flat back view: Back view:
Recommended Installation Spacing:
W10388775
06/2011
WED7300X, WED7400X,
WED7600X, WED7800X
Bottom view:
Spacing for recessed area or closet installation
All dimensions show recommended spacing allowed, with
tested spacing of 0” (0 mm) clearance on sides and rear.
■ Additional spacing should be considered for ease of
installation and servicing.
■ Additional clearances might be required for wall, door,
and oor moldings.
■ Additional spacing should be considered on all sides
of the dryer to reduce noise transfer.
■ For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilitation openings are
acceptable.
■ Companion appliance spacing should also be considered.
Dryer with Extended back view:
NOTE: Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See
“Venting Requirements.”
To Next Page
Need help?
General