Whirlpool WEG730H0D - User Manual

30" (76.2 cm) Slide-in Gas Range
PRODUCT MODEL NUMBERS
WEG730H0D WEG760H0D
GAS SUPPLY REQUIREMENTS
Gas supply line:
• Provide a gas supply line of
3
⁄4" (1.9 cm) rigid pipe to the
range location. A smaller size pipe on longer runs may
result in insufcient gas supply. With LP gas, piping or
tubing size can be
1
⁄2" (1.3 cm) minimum. Usually, LP gas
suppliers determine the size and materials used in the
system.
NOTE: Pipe-joint compounds that resist the action of LP
gas must be used. Do not use TEFLON
®†
tape.
Flexible metal appliance connector:
• If local codes permit, a new CSA design-certied, 4 to
5 ft (122 to 152.4 cm) long,
1
⁄2" (1.3 cm) or
3
⁄4" (1.9 cm)
I.D., exible metal appliance connector may be used for
connecting range to the gas supply line.
• A
1
⁄2" (1.3 cm) male pipe thread is needed for connection
to the female pipe threads of the inlet to the appliance
pressure regulator.
• Do not kink or damage the exible metal tubing when
moving the range.
• Must include a shutoff valve:
The supply line must be equipped with a manual shutoff
valve. This valve should be located in the same room but
external to the range opening, such as an adjacent cabinet.
It should be in a location that allows ease of opening and
closing. Do not block access to shutoff valve. The valve is
for turning on or shutting off gas to the range.
A. Gas supply line
B. Shutoff valve “open” position
C. To range
Gas Pressure Regulator
The gas pressure regulator supplied with this range must be
used. The inlet pressure to the regulator should be as follows
for proper operation:
Natural gas:
Minimum pressure: 5" WCP
Maximum pressure: 14" WCP
LP gas:
Minimum pressure: 11" WCP
Maximum pressure: 14" WCP
Contact local gas supplier if you are not sure about the inlet
pressure.
PRODUCT DIMENSIONS
This manual covers several models. Your model may appear
different from the models depicted. Dimensions given are
maximum dimensions across all models.
A. 1
3
⁄16 " (3.0 cm) height from
cooktop to top of vent
B. 29
7
⁄8 " (75.9 cm)
C. Model/serial number plate
(located behind the oven door on
the top right-hand side of the
oven frame)
D. 36" (91.4 cm) height to top of
cooktop edge with leveling legs
screwed all the way in*
E. 28
5
⁄16 " (71.9 cm) max.
depth from front of console
to back of range.
F. 28
7
⁄8 " (73.3 cm) max. depth
from handle to back of
range.
IMPORTANT: Range must be level after installation. Follow the
instructions in the “Level Range” section. Using the cooktop as
a reference for leveling the range is not recommended.
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
Type of Gas
Natural gas:
• This range is factory set for use with Natural gas. See “Gas
Conversions” section. The model/serial rating plate located
behind the control panel has information on the types
of gas that can be used. If the types of gas listed do not
include the type of gas available, check with the local gas
supplier.
LP gas conversion:
Conversion must be done by a qualied service technician. No
attempt shall be made to convert the appliance from the gas
specied on the model/serial rating plate for use with a different
gas without consulting the serving gas supplier. See “Gas
Conversions” section.
†®
TEFLON is a registered trademark of E.I. Du Pont De Nemours and
Company.
Page 1 of 2
Ref. W10665256E
08/15
B
D
A
F
E
C
A
B
C

Summary

Gas Supply Requirements

Gas Supply Line

Provide a 3/4" rigid pipe. Smaller pipes may cause insufficient supply. LP gas may use 1/2" minimum piping.

Flexible Appliance Connector

Use a CSA-certified, 4-5 ft long, 1/2" or 3/4" I.D. flexible metal connector if local codes permit.

Shutoff Valve Requirement

The supply line must include a manual shutoff valve in the same room, easily accessible for opening/closing.

Gas Pressure Regulator

Use the supplied regulator. Ensure inlet pressure meets specified minimums for natural gas and LP gas.

Type of Gas

Range is factory set for Natural gas. Conversion to LP gas must be done by a qualified technician.

Product Dimensions

Vent Height

Dimension A: 13/16" (3.0 cm) height from cooktop to top of vent.

Overall Height to Console

Dimension B: 29 7/8" (75.9 cm) height from base to top of console.

Max Depth to Console

Dimension E: 28 5/16" (71.9 cm) max. depth from console front to range back.

Max Depth to Handle

Dimension F: 28 7/8" (73.3 cm) max. depth from handle to range back.

Electrical Requirements

Grounding and Circuit

Must be grounded per local codes or NEC/CEC. A 120V, 60Hz, 15-amp fused circuit with time-delay fuse/breaker is recommended.

Polarity and Voltage Check

Electronic ignition requires proper grounding and polarity. Check outlet for 120-volt power and correct grounding.

Cabinet Opening Dimensions

Standard Opening Sizes

Dimensions shown for 25" countertop depth, 24" base cabinet depth, 36" countertop height.

Clearance Requirements

Minimum clearances for side cabinets, opening width, and from cooktop to cabinets are specified.

Zero Clearance to Combustible Walls

Range may be installed next to combustible walls with zero clearance.

Cooktop to Cabinet Clearance

30" (76.2 cm) minimum clearance between cooktop and uncovered wood/metal cabinet.

Whirlpool WEG730H0D Specifications

General

Brand	Whirlpool
Model	WEG730H0D
Category	Ranges
Language	English