STORAGEDRAWER OR WARMING DRAWER (on some
models)
Check that storage drawer or warming drawer is cool and empty
beforecleaning.
Cleaning Method:
• Mild detergent
OVEN CAVITY
Do not use oven cleaners on models with self-clean.
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
Cleaning Method:
• See the "Self-Cleaning Cycle" section, if available on your
model.
The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
To Replace: 4. Replace bulb, then bulb cover by turning clockwise.
1. Unplug range or disconnect power. 5. Plug in range or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.whirlpool.com
Operation
PROBLEM POSSIBLE CAUSES SOLUTIONS
Nothing will operate Power supply cord is unplugged. Plug into a grounded outlet.
Household fuse is blown, or a Replace the fuse or reset the circuit breaker. If the problem
circuit breaker is tripped, continues, call an electrician.
The control displays an F9 or F9 The electrical outlet in the home may be miswired. Contact a
E0 error code. qualified electrician to verify the electrical supply.
The control knob is not set Push in knob before turning to a setting.
correctly.
On ceramic glass models, the
oven control lockout is set.
Cooktop will not operate
See the control lock keypad feature in the "Feature Guide."
Excessive heat around Cookware is not the proper size. Use cookware about the same size as the surface cooking
cookware on cooktop area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Cooktop cooking results not Control knob set to incorrect heat See "Cooktop Use" section.
what expected level
Cooktop element cycles on
and off on High setting.
Oven will not operate
Range is not level.
Element cycling due to a
temperature limiter
Delay start is set.
Control lock is on.
Level the range. See the Installation Instructions.
This is normal operation. The element may cycle on and off to
keep the cooktop from overheating.
See "Cook Time" section.
Press and hold START for 3 seconds to unlock.
Control is in Demo Mode.
Electronic oven control set
incorrectly
Press and hold START TIME for 10 seconds to exit Demo
Mode. Demo Mode is used for display models in a showroom.
See "Electronic Oven Controls" section.
Oven temperature too high or Oven temperature needs See "Oven Temperature Control" in the "Electronic Oven
too low adjustment. Controls" section.
Oven indicator lights flash Power to range is turned on or See "Control Display" in the "Electronic Oven Controls"
restored, section. If the indicator lights keep flashing, call for service. See
cover for contact information.
13
To Next Page
Loading...
