EasyManua.ls Logo

Whirlpool WFW9151YW - User Manual

Whirlpool WFW9151YW
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
$10 $71
$
16
Cost range based only on standard capacity models.
Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per kWh and natural gas cost of
$1.218 per therm.
For more information, visit www.ftc.gov/appliances (P/N W10404646)
U.S. Government Federal law prohibits removal of this label before consumer purchase.
Cost Range of Similar Models
Clothes Washer
Capacity: Standard
Whirlpool Corporation
Models: WFW9151Y*, WFW9351Y*
Cat. H1WB6A2B(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
154 kWh
Estimated Yearly Electricity Use
Your cost will depend on your utility rates and use.
$12
Estimated Yearly Operating Cost
(when used with a natural gas water heater)

Questions and Answers

  • T
    Timothy JonesAug 3, 2025
    What to do if Whirlpool WFW9151YW won't start after cycle?
    • E
      Elizabeth GibsonAug 3, 2025
      If your Whirlpool washer won't start after a cycle, ensure that after any wash cycle is completed, the door must be opened and then closed before a new cycle can begin.
  • C
    Clifford GatesAug 10, 2025
    What to do if my Whirlpool Washer stops mid-cycle?
    • M
      mackenzie61Aug 10, 2025
      If your Whirlpool washer stops mid-cycle, it could be due to several reasons: * The washer pauses for approximately 2 minutes during certain cycles. Allow the cycle to continue. * The washer may stop to reduce suds. Only use HE detergent. Suds from regular detergents can slow or stop the washer. Always measure detergent and follow manufacturer's directions based on your load requirements. To remove suds, cancel the cycle, select RINSE/DRAIN & SPIN, and press START/PAUSE. Do not add more detergent. * The door must be closed during operation. * The washer pauses for about 2 minutes during certain cycles. Allow the cycle to continue. Some cycles feature periods of tumbling and soak.
  • C
    Christopher StephensonAug 17, 2025
    What to do if my Whirlpool WFW9151YW Washer is unbalanced?
    • J
      Jeffrey HammondAug 17, 2025
      If your Whirlpool washer seems unbalanced: * Remove several items and rearrange the load evenly in the drum. Close the door and press START/PAUSE. * Avoid adding more than 1 or 2 additional garments after a cycle has started to prevent tight packing or unbalancing. * Do not add more water to the washer.
  • M
    Mary BaldwinOct 25, 2025
    Why won't my Whirlpool WFW9151YW Washer start?
    • G
      Gina PerezOct 25, 2025
      Several factors can prevent your Whirlpool washer from starting: * **Power Supply:** Ensure the power cord is correctly plugged into a grounded 3-prong outlet and that the outlet has power. Avoid using extension cords. Check the electrical source, and if the voltage is low, consult an electrician. * **Circuit Breaker/Fuses:** Reset any tripped circuit breakers or replace blown fuses. If issues persist, contact an electrician. * **Door:** Make sure the door is completely closed and latched. The washer won't run if the door isn't properly shut. * **Start/Pause Button:** Press and hold the START/PAUSE button for 1 second to initiate the cycle. * **Cycle Interruption:** The washer pauses during certain phases of the cycle. Allow the cycle to continue without interruption. Some cycle...

Whirlpool WFW9151YW Specifications

General IconGeneral
BrandWhirlpool
ModelWFW9151YW
Washer TypeFront Load
Capacity4.5 cu. ft.
Width27 in
ColorWhite
Energy Star CertifiedYes
Number of Wash Cycles12
Voltage120 V
Frequency60 Hz
Height39 inches

Related product manuals