To Next Page
C
Charles StewartOct 28, 2025
What to do if my Whirlpool Washer is not performing as expected?
- CChelsea ReyesOct 29, 2025
If your Whirlpool washer isn't performing as expected, make sure both the hot and cold water faucets are fully turned on and that both hoses are properly attached, allowing water to flow to the inlet valve. Also, inspect the inlet valve screens for any clogs and check the inlet hoses for kinks that might be restricting water flow. Ensure the power cord is plugged into a grounded 3-prong outlet, avoiding the use of extension cords, and verify that the outlet has power. If voltage is low, consult an electrician. Reset any tripped circuit breakers or replace blown fuses. Remember, the door must be completely closed and latched for the washer to operate. Note that the washer pauses during certain phases of the cycle, and some cycles include tumbling and soak periods. The washer may also stop t...
General
