EasyManua.ls Logo

Whirlpool WT1715Q - Electrical Characteristics; Before Calling a Technician

Whirlpool WT1715Q
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Electrical Characteristics
Models CuFt
Rated
Voltage
(V)
Nominal
current
(A)
Nominal
Frequency
(Hz)
Estimated
power consumption
(kWh/
year)
LWT1840D
18 127 6,
0 60 454
LWT1840Q
18 127 6,
0 60 454
LWT1860A
18 127 6,
0 60 454
WT1726N
1
7 127 1,6 60 442
WT1736N
1
7 127 1,6 60 442
WT1726A
1
7 127 1,6 60 442
WT1800N
18 127 1,6 60 454
WT1818A
18 127 1,6 60 454
WT1
840N
1
8 1
27 1,6 60 454
WT1
850D
1
8 127 1
,6 60 454
WT1756A
1
7
127 1,1 60 363
WT1865A
18 127 1,1 60 382
WT1715Q
17 127 1,6 60 442
WT1860A
18 127 1,6 60 454
If after following the instructions in this guide, the refrigerator does not work, call the listed service
centers.
Service - Latin America
For other Latin American countries, see our Latin-American Warranty Certificate and visit our Latin-American
Whirlpool website www.whirlpool-latam.com, select your country and then Menu Customer Service.
Before calling a technician
Magnetic
gasket
Leveler
screws
Compressor
Condenser
Figure 1
VERY IMPORTANT:
BEFORE YOU CALL A TECHNICIAN ENSURE THAT THE INSTRUCTIONS IN THIS INSTALLATION
MANUAL USE AND CARE WERE CORRECTLY FOLLOWED. EVEN IF THERE ARE SO DOUBTS OVER
THE COOLER OPERATION, SEE THE SOLUTIONS FOR SEVERAL PROBLEMS BELOW.
IF THE REFRIGERATOR DOES NOT WORK
Connect the power cord properly, DO NOT USE EXTENSIONS.
Review the ELECTRICAL OUTLET, AS IT MAY BE DAMAGED, connect another device and make sure
it is working.
Avoid connecting multiple devices at the same time; IT MAY CAUSE A POWER SUPPLY OVERLOAD.
THE PRODUCT SHOULD NOT BE INSTALLED NEAR HEAT SOURCES (stove, heaters, etc.) or where
it can be exposed to direct sunlight.
THE DOORS MUST CLOSE HERMETICALLY, check the magnetic gaskets of the doors.
LEVEL THE REFRIGERATOR, remove the wooden bases and adjust the leveling screws (figure 1).
DO NOT OVERLOAD THE REFRIGERATOR, cold air circulation will be poor.
Position the TEMPERATURE control IN NORMAL POSITION (average cold) and wait at least 24 hours
to change the temperatur
e again.
NOTE THAT THE REFRIGERATOR WORKS FOR A PROLONGED TIME
Make sure the CONDENSER IS FREE OF DUST AND GARNETTED (figure 1)
AVOID OPENING THE REFRIGERATOR DOOR OFTEN or for long periods of time.
DO NOT PLACE WARM FOOD and keep them covered.
LISTENING STRANGE NOISES
Make sure that there are NO OBJECTS ON OR BEHIND THE
REFRIGERATOR.
THE COMPRESSOR DOES NOT WORK PROPERLY, may be due tothe
low voltage in the power grid. Check the light intensity, and if low,
indicates low voltage, contact the power company to fix the power
supply (figure 1).

Related product manuals