whisker Litter-Robot 4 - Page 2

Ensure Proper Placement
Power On
Add Lier
1
3
2
4
If possible, place the Lier-Robot in the same location
as the old lier box (at least during transition).
Make sure the unit is indoors on a rm, level suace and in a
cool, dry location. Must not be touching any walls.
Place lier mats or rugs in front of the unit.
The Lier-Robot will now peorm an initial clean cycle.
Need help? Visit whiskersuppo.com
Use clumping lier or lier beads and crystals that are small
enough to pass through the screen.
Add lier until it meets the raised MAX ll line when spread
flat (8-10 lbs or 3.6-4.5 kg). Be careful not to oveill.
Download the Whisker app
and follow the onboarding
instructions.
Lier Fill Line
Plug the small end of
the power supply into
the power input on the
back of the base.
Plug the AC/DC
adapter into a wall
outlet.
Press the Power
buon on the control
panel.
Download The App
Note: During initial clean cycle, the cat sensor weight scale is
disabled to ensure proper calibration.