whisker Litter-Robot 4 - Page 3

Power
Press the Power buon to turn
the robot ON or OFF.
The robot will begin a clean cycle
when power is turned on.
Connect
Press the Connect buon to turn the
WiFi ON or OFF.
A long press, while at the home position,
will initiate the onboarding process.
Cycle
Press the Cycle buon to sta a
clean cycle.
If already cycling, press Cycle to
pause; press again to resume a cycle.
A long press, while at the home
position, will enter sleep mode.
Reset
Press the Reset buon to zero the
weight scale.
A long press, while at the home position,
will enter night light seing mode.
If already cycling, press Reset to pause
a cycle; press again to cancel a cycle.
If already cycling, a long press will
reset the cat sensor weight scale.
Empty
Press the Empty buon to sta
an empty cycle.
If already cycling, press Empty
to pause.
A long press, while at the home
position, will enter wait time
seing mode.
Control
panel
icons