11
External Power
Always turn the scanner off before
connecting or disconnecting power
sources. Use the supplied USB cable
to connect the scanner to a USB power
source (not included).
Some USB power adapters can interfere
with the scanner's reception. Using an
incompatible USB cable may damage
your scanner.
NOTE: If your vehicle’s engine is
running, you might hear electrical noise
from the engine while scanning. This is
normal.
Swivel Belt Clip
Swivel clip allows the scanner to
move with you and easily move it
out of the way without unclipping it
from your belt. To attach the Swivel
clip to the scanner; align the belt clip
grooves to the slots on the back of
the scanner. Slide the clip down until
it clicks in place. To remove the belt
clip, pull back on the small tab and
slide the clip upward.
To Next Page
Loading...
Need help?
General
