•
Place one end of the spinnaker sheet through the tack of the the spinnaker and tie off
with a stopper knot
•
With the other end of the sheet run it around the out side of the stainless bridle wire
and then feeding it though the spinnaker block. Make sure it follows the arrows on the
block this shows the direction of the ratchet
•
Run the sheet across the boat and though the opposite spinnaker block and back to
the spinnaker clew
•
Make sure that the sheets are set up inside the spinnaker luff to make sure the kite will
jibe inwards
Spinnaker Sheet
16
To Next Page