What to do if White Point WPW 5413 Washer does not intake water?
If your White Point Washer isn't taking in water, here's what you should check: First, make sure the water tap is turned on. Next, inspect the water inlet hose for any twists and untwist it if necessary. Also, the water inlet hose or the valve inlet filter might be clogged, so clean these filters. Finally, ensure that the machine door is completely closed.
Why my White Point Washer does not start?
Your White Point Washer might not start due to several reasons: it may not be plugged in, so ensure it is properly connected to the power outlet. Check the fuses and replace them if they are out of order. Verify that there is no electricity cut-off by checking the mains power. Make sure you have pressed the Start/Pause button. Ensure the program dial is not in the ‘stop’ position; if it is, switch it to the desired program. Finally, confirm that the machine door is completely closed.
Guidance on the proper application and intended use of the washing machine.
Important cautionary advice for safe and efficient operation of the appliance.
Critical safety precautions to prevent potential injuries and risks during operation.
Step-by-step procedure for removing transit safety screws before first use.
Guidelines for safely connecting the washing machine to the electrical power outlet.
Procedure for correctly connecting the water supply hoses to the machine's inlet valve.
Instructions for properly attaching the drain hose for water expulsion.
Important safety precautions to observe before performing maintenance and cleaning.
General| Brand | White Point |
|---|---|
| Model | WPW 5413 |
| Category | Washer |
| Language | English |
To Next Page