4
Power On
1. Hold the unit away from the
ground and any metal.
2. Quickly press and release the
button. The Bullseye TRX will
beep once followed by two
short beeps indicating that it’s
ready to use.
Power Off
1. Press and hold the button for
half a second.
2. When you hear a two-tone
beep, release the button. The
unit will power down.
Ground/Target Reset
During operation, a quick press of
the button performs a “grab”
function. In the absence of a target,
this grabs the ground phase and
resets the ground balance. In the
presence of a target, it can be used
to ratchet in on strong target
signals.
Beep or Vibration Selection
The Bullseye TRX can indicate target
proximity with either an audible
beep or a vibration response. Both
are “on” by default, but it is
recommended that you choose one
or the other to minimize battery
drain.
1. Turn the unit on.
2. Press and hold the button for
half a second, and listen for the
two-tone power-down jingle.
3. Continue holding down the
button. After two more
seconds, the Bullseye TRX will
enter Setup Mode, signified by
a two-tone “boo-beep.”
4. Continue holding down the
button. After another two
seconds, the Bullseye TRX will
begin to cycle through the
beeper/vibration selections:
• Beeper and vibrator
• Beeper only
• Vibrator only
Note: the selection always starts
with the currently selected mode.
5. When you reach the desired
selection, simply release the
button and the Bullseye TRX
will exit setup, indicated by two
short beeps.
Changes to this setting are
automatically saved when the TRX
is powered off.
Operation
To Next Page
Loading...
