White OMEW Series - Page 14

14
WHITE can accept no responsibility for possible errors in catalogues, brochures, and other printed material. WHITE reserves the right to alter its products without noce. This also applies to products already on
order provided that such alteraons can be made without subsequent changes being necessary in specicaons already agreed.
All trademarks in this material are the property of the respecve companies. WHITE and the WHITE logotype are trademarks of WHITE Drive Motors & Steering LLC and WHITE Drive Motors and Steering Sp. z o.o..
All rights reserved.
8. Remove distributor plate (18) and O-ring
(5).
The needles will fall out of the needle
bearing (16) during dismantling and can be
collected for reuse. The outer ring and
thrust bearing (17) need not be removed.
9. Remove disc valve (15)
10. Remove sha (11) With the housing
standing on the work wrench, press the
sha out of the housing. Collect the
needles for possible reuse
11. Remove balance plate (14), O-ring (12)
and spring washer (13).