White OMEW Series - Assembly

15
WHITE can accept no responsibility for possible errors in catalogues, brochures, and other printed material. WHITE reserves the right to alter its products without noce. This also applies to products already on
order provided that such alteraons can be made without subsequent changes being necessary in specicaons already agreed.
All trademarks in this material are the property of the respecve companies. WHITE and the WHITE logotype are trademarks of WHITE Drive Motors & Steering LLC and WHITE Drive Motors and Steering Sp. z o.o..
All rights reserved.
12. Turn the housing. Gently lever the dust
seal ring (3) from the housing with a
screwdriver.
13. Fit the extractor between the housing and
sha seal. Press sha seal (6) , bearing
race (7), axial needle bearing (8) and radial
needle bearing (9)out using hydraulic
pressure equipment.
Aer dismantling, clean all parts in low aromac kerosene. Replace all O-rings and sha
seal. Immediately before assembly, lubricate all parts with hydraulic oil and grease rubber
parts with vaseline.
Assembly
1. Place the sha seal (6) on mandrel SJ
151-9000-18 and mount the sha seal
into the motor housing (4)
Note:
Remember about a new sha seal.
2. Mount the bearing race (7) (2 o ) and
the axial needle bearing (8)
Note:
The bearing race can be ed in any posion.