8.0: TORQUE SETTINGS
Torque explained: If no suitable Torque Wrench is available a Torque of 5 lbf.ft can be obtained by applying a force of 5lb, with a Spring Balance,
to the end of a spanner, 1 Foot in length.
IMPORTANT: For all other torque settings, refer to the specific manufacturers information bundled with this manual, or alterna-
tively, refer to the specific manufacturers website for further information.
9.0: OWNER’S NOTES
Seat Post Clamp
M6 Cap Screw
12 (Min) - 14 (Max) 8.9 (Min) - 10.3 (Max)
To Next Page
Loading...
