Caution
Failing to follow instructions marked with this symbol may cause slight injury or damage to the product.
Usage Related
- Disconnect all cables connected to the product before cleaning it.
There is a danger of electric shock or damage to the product.
- Do not connect a phone line connected to a digital phone to the modem.
There is a danger of a electric shock, fire or damage to the product.
- Do not place any container filled with liquids over or near the product.
If liquids enter the product, this may cause fire or electric shock.
- If the product is broken or dropped, disconnect the power cord and contact a service center for a safety
check.
Using a broken product may cause electric shock or fire hazard.
- Avoid direct sunlight when the product is in an air-tight location such as inside a vehicle.
There is a danger of a fire hazard. The product may overheat.
- Do not place a candle, lighted cigar, etc. over or on the product.
There is a danger of fire.
- Make sure to have the product tested by a safety service engineer after repairing the product.
Authorized Repair Centers will carry out safety checks after a repair. Using a repaired product without testing it
for safety might cause electric shock or fire.
- In case of lightning immediately turn the system off, disconnect the power cord from the wall outlet and
line.
There is a danger of electric shock or fire.
- Connect only permitted devices to the connectors or ports of the product.
Failing to do so may cause electric shock or fire.
- Take care not to drop the product while using it.
This may cause personal injury or loss of data.
- When handling parts of the product follow the instructions on the manual supplied with the parts.
Failing to do so may cause damage to the product.
- If the product emits smoke or there is a burning smell, disconnect the power plug from the wall outlet
and contact a service center.
There is a danger of fire.
Custody and Movement Related
- Follow the instructions for the relevant location (e.g. airplane, hospital, etc.) when using a wireless
communication device (wireless LAN, Bluetooth, etc.).
Installation Related
- Do not block the ports (holes), vents, etc. of the product and do not insert objects.
Damage to a component within the product may cause electric shock or fire.
- Do not block vents.
Failing to do so may cause the internal temperature of the product to rise and the product to malfunction or halt.
- Do not place a heavy object on the product.
This may cause a problem with the product. In addition the object may fall and cause injury or damage the product.
05
To Next Page
Loading...