Wickes PSC1904.1 - Class 2 Laser Safety Details

6
towards the eye.
4. Always ensure the laser beam is aimed at a sturdy work piece without reective surfaces, e.g. wood or rough-
coated surfaces are acceptable. Bright shiny reective sheet steel or similar is not suitable for laser applications
as the reective surface may direct the laser beam back at the operator.
5. Do not change the laser device with a different type. The manufacturer or an authorized agent must carry out
repairs.
6. CAUTION: Use of controls or adjustments other than those specied herein may result in hazardous radiation
exposure.
Additional safety warning for class 2 laser
The laser device tted to this tool is CLASS 2 with a maximum radiation of 1.5mW and 650nm wavelength.
CLASS 2 LASER RADIATION, DO NOT STARE INTO BEAM
GENERAL SAFETY WARNINGS FOR YOUR LASER