15
IMPORTANT NOTE: Never stare directly
into the laser beam and never point the
beam at anybody. The laser beam energy is
extremely harmful to your eyes.
The laser guide is for the purpose of precision cutting.
Depress the on/off switch for laser, the laser guide then
projects a visible red line on the workpiece surface.
Make your cut along the red line. The laser will turn off
automatically if the saw is turned off.
NOTE: The sawdust may block the laser beam, clean the
laser lens periodically.
6. USING THE LASER GUIDE (SEE FIG. I1, I2)
Fig. I2
Fig. I1
25
If your power tool becomes too hot, run your circular saw no load for 2-3 minutes to cool the motor. Avoid prolonged
usage at very low speeds.
Always use a blade suited to the material and material thickness to be cut. The quality of cut will improve as the number
of blade teeth increases.
Always ensure the work-piece is rmly held or clamped to prevent movement. Support large panels close to the cut line.
Any movement of the material may affect the quality of the cut. The blade cuts on the upward stroke and may chip the
uppermost surface or edges of your work piece. When cutting, ensure your uppermost surface is a non-visible surface
when your work is nished. Feeding too fast signicantly reduces the performance of the machine and shortens the life
of the saw blade. Always face the good side of the work-piece down, to ensure minimum splintering. Only use sharp saw
blades of the correct type.
WORKING HINTS FOR YOUR CIRCULAR SAW
To Next Page
Loading...
