5 February, 2024 7 Rev. A-14
INSERT 1/16 HEX DRIVER TO
ADJUST. TURN CCW TO LOOSEN,
CW TO TIGHTEN.
Tightening Tilt Adjustment Screws
INSERT .050 HEX DRIVER TO
ADJUST. TURN CCW TO LOOSEN,
CW TO TIGHTEN.
Tightening NVG Interface Screws
CARE AND MAINTENANCE
To maintain the reliability of the all the adjustments to the mount, keeping the
mount clean of any saltwater residue and/or dirt after each use will promote a long-
anticipated service life. Flushing the mount with fresh water or by wiping it with a clean
damp cloth and lightly lubricating the stainless-steel parts will ensure its intended
use. After performing this procedure check all adjustments to assure they are all
working properly. If any play develops in the Carriage or Pivot mechanism, the following
adjustments can be made to restore its original movement.
Wilcox prides itself in providing the operator with the most trusted mount in the world.
To accomplish this, it is essential to understand the science behind our mounting
solution. Without a stable mounting system, an adverse condition can develop that
compromises the reason for its existence. Wilcox has engineered the helmet Shroud,
Mount, and NVG Shoe to work as one system. Any off-brand shrouds could affect the
rigidity, thereby affecting the stability of the goggle. An extensive amount of effort is
put into this, and Wilcox cannot honor a warranty claim if an off-brand shroud is used
with our mount.
To Next Page
Loading...