EasyManua.ls Logo

Wildix WP410 - Appendix 3 - Phone Settings

Wildix WP410
13 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WP410, WP480G, WP490G Wildix Phones Guide
WP410, WP480G, WP490G Wildix Phones Guide
Page 13 of 13
Call reject: On / Off - if enabled, all calls are rejected
Call forwarding - call forwarding settings
busy: On / Off - enable / disable call forwarding when busy
unavailable: On / Off - enable / disable call forwarding in case of no answer
forced: On / Off - enable / disable forwarding of all calls
You can set the destination for each type of call forwarding: enter the phone number or the
value VOICEMAIL
Call waiting: On / Off - enable call waiting to be able to receive more than one call at a time
Mobility: On / Off - if enabled, after a timeout, incoming calls are routed also to your mobility
extension number; phone number and timeout can be specified in Collaboration Settings
Ring Tone: select the ringtone
Appendix 3 - Phone Settings
To access Phone Settings, press soft key from idle:Menu
Status: view IP, Mac, Firmware of your phone
Backlight settings: set the backlight level of the screen and select the timeout (min - 20 sec, max - 1
after which the phone's screen should turn off hour or Always On)
Note: The backlight settings of WP490EXT extension module are synced with WP490G.
Audio settings: adjust Talk, Tone, Mic, Key, Ring Volume, Headset Ring Mode (allows you to decide
whether ringtone should be played via Headset or Handset when Headset is connected) and
Handsfree sound input (allows you to select the active microphone during the "hands-free+handset
picked up" mode)
Network: access to this menu is recommended for PBX administrator
Autoprovision: access to this menu is recommended only for PBX administrator
Note: When Call forwarding is activated for all calls for internal or external call class,
CFN label (Call Forwarding Number) indicating the destination (extension number/
external number/ Voicemail) and the arrow icon is displayed on the screen; in case call
forwarding of both internal and external call class is activated, call forwarding number
for internal calls is displayed on the screen.
Note: The backlight settings of synced with WP490EXT extension module are WP490G
2016-2017.

Related product manuals