Default: OFF
Real-Time Auto ID
If ON, Auto-ID will run immediately after concluding a recording
and the Auto-ID pop-up will be displayed.
Values: ON, OFF
Default: ON
Real-Time Auto ID Sensitivity
Adjusts how conservative the ID results will be. On SENSITIVE,
more bats will be identified even if the algorithm is less confident
of the result. On ACCURATE, only bats in which the algorithm is
very confident will be shown. BALANCED is in between.
Values: SENSITIVE, BALANCED, ACCURATE
Default: SENSITIVE
Trigger Sensitivity
Adjusts the recording trigger sensitivity level. High is extremely
sensitive and maximizes detection, but will also trigger from
other noises resulting in NOISE files. Low will only trigger on
stronger signals that are likely to be able to be identified.
Medium is somewhere in between the two extremes. The trigger
only applies to signals that are higher in frequency that the
Trigger Minimum Frequency setting in the Spectrogram
Settings panel.
Values: LOW, MEDIUM, HIGH
Default: MEDIUM
Trigger Window
The recording continues for this amount of time after the last
signal that satisfies the trigger. (The recording is also truncated
when it reaches the maximum recording duration set by Max
Trigger Length.) Set the trigger window setting long enough to
To Next Page
Loading...