11. Table of Parameters 12. Instructions of seat assembly (accessory not included)
1. Seat components a, b, c 2. Insert seat post b into seat a
3.Make seat post b vertical to seat a,
and tighten it with a wrench.
4. Insert the seat into seat tube c, and
tighten the screw rod and press down
the seat clamp as shown in the figure.
5. The seat assembly is completed 6.Insert the assembled seat bottom
into the hole on the foot rest of the
scooter.
7. Open the safety ring. 8.Pull open the fixed handle, and
move the seat post downward.
1. The maximum cruising speed is measured at the temperature of 25℃, payload of 60kg, full electric voltage and flat pavement. Factors like driving habit,
environmental temperature, road surface condition, payload etc. will affect the max speed.
2. The traveling range is measured at the temperature of 25℃, about 15km/h, the payload of 60 kg and flat pavement. Factors like driving habit,
environmental temperature, road surface condition, payload etc. will affect the continuous travel mileage.
3. The gradeability is measured at the temperature of 25℃, the payload of 60 kg. Factors like driving habit, environmental temperature, payload etc. will affect
max gradeability
9. Tighten screw with a hexagonal
wrench.
10. Fasten the fixed handle. 11.Lock the safety ring. 12.Seat assembly completed.
Data of the electric scooter
Folded Length*width*height
13.9kg
Cement roads,asphalt roads,flat earth
roads,steps lower than 1cm,ditches less than
3cm in width
Intellegent battery manage system
Abnormal temperature /short circuit
/undervoltage automatic dormancy /
overcharge and overdischarge protection
To Next Page
Loading...
