7
COFFEE BREWER · CM8B-A100, CM8T-A100
EN
BEFORE USE
ELECTRICAL CONNECTION
Check that the voltage where you shall use the unit is the same as that specied
on the unit. Details can be found on the label on the unit’s base plate.
WHEN USING THE UNIT FOR THE FIRST TIME
Remove the water tank by twisting it clockwise. Twist it anti-clockwise to place it.
Please run 1L fresh water through the unit without using a coffee lter or coffee
prior to using the unit for the rst time.
OPERATION
• Place the Wilfa Performance on a at surface. Plug the power cord into the
socket.
• Fill the water tank with fresh water to the desired amount. Place a lter paper
(1x4) in the lter holder. Place the recommended amount of coffee into the
lter.
• We recommend that you use lter ground coffee, 60 g per litre of water.
Experiment with the coffee quantities for the rst few brewing’s to nd the
amount which you think is optimal.
• We also recommend that you use a Wilfa scale for best results.
• Attach the lter holder to the bracket.
• We recommend the following ratios of water and coffee (please note that
different grinds and coffee types will inuence these ratios somewhat):
1 l - 60 g
0,75 l - 45 g
0,50 l - 30 g
• Press the start button to start the brewing process. Wilfa Performance has
Wilfa’s unique pump system which transports water through the system at an
optimal temperature from the rst to the last drop.
• When the brewing process is complete, the unit will switch over to the keep
warm state. The start button will remain lit up. After 40 minutes the coffee
To Next Page
Loading...
Need help?
General
