23
➋ Use the continuous drainage option from the middle hole.
Note: Water can be automatically emptied into a floor drain by attaching 14mm inner diameter
hose (not included).
1. Remove the continuous drain cap 1 by turning it counter clockwise then remove
the rubber stopper 2 from the spout.
➊
2. Screw the drain connector to(included in the package) the spout by turning
clockwise.
3. Insert the drainage hose into drain connector.
➋ ➌
ATTENTION:
When using continuous drainage option from the middle hole, place portable on a level
surface and make sure garden hose is clear of any obstructions and is directed downward.
Placing portable on an uneven surface or improper hose installation may result in water filling
up the chassis and causing the unit to shut off. Empty water in the chassis if shut off occurs,
then check portable location and hose for proper setup.
To Next Page
Loading...
